Yet Another LED Str...
 
Notifications
Clear all

Yet Another LED Strip PCB

11 Posts
4 Users
0 Reactions
8,865 Views
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago
[#15151]

Last year I missed out on some of these over at ACL. Circumstances just weren't write.

So I have been thinking a lot lately about do some small PCB strip 15x 230mm ( about .6x9") with discrete constant current sources.

The real PITB is having to send +24v, Gnd and the switched Gnds to the strip. Also I haven't thought of a clean way of connecting multiple strips together yet.

what do you think?

Descrete Constant Current LED strips

10 Replies
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

I think that you should reverse the BAV99 diodes.


Reply
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago

Yes of course.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

I think that circuit is fine. Not very precise because the current will vary somewhat with temperature, HFE variations, and the Vf of the LEDs, but it will be good enough. And it will probably be cheaper, with a lower voltage drop than the customary LM317 circuit.

Do you think that you could just send switched ground to the board, and connect the base resistor to that? I guess that would be a bit slower than always connecting the base to ground, but that might not matter.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

You might look at supertax CL2 constant current drivers - they aren't super expensive, have temperature compensation and support a wide range of voltage. You can double them up to get you to 20 or 40 mA. The only issue is they aren't widely available.


Reply
Page 1 / 3
Share: