WS2801 controllers
 
Notifications
Clear all

WS2801 controllers

36 Posts
14 Users
0 Reactions
31.5 K Views
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Hey MPH - can you provide a quick comparison between the open version and the T3-Pro? pros, cons, etc...

Thanks! May have to drag out the etchant stuff again...


Reply
mrpackethead
Posts: 2289
(@mrpackethead)
Famed Member
Joined: 19 years ago
budude wrote:Hey MPH - can you provide a quick comparison between the open version and the T3-Pro? pros, cons, etc...

Thanks! May have to drag out the etchant stuff again...

The Pro is not open-source, its got different uP, its got an effects engine and its completely built up, comes with support and warranty.. Its also much more expensive than building your own.


Reply
n8huntsman
Posts: 562
(@n8huntsman)
Honorable Member
Joined: 16 years ago
mrpackethead wrote:Actually i had 2000 nodes running in a chain once, and they were running at 1.2Mhz.. The first hop was about 7m and then its regnerated every 100mm

I think I'm misunderstanding something. How do you run 2000 in one chain? You can't connect multiple univereses together can you?


Reply
mrpackethead
Posts: 2289
(@mrpackethead)
Famed Member
Joined: 19 years ago

you can hook mulitple universes together,


Reply
Posts: 2
(@made-in-china)
New Member
Joined: 15 years ago
Matt_Edwards wrote:These chips are used in the commercial Pixels. They offer 3 channels of 8bit PMW with programmable constant current source. At a street price of 20cent each they are also damn good value.
I am thinking of a small remote controller

Basic Spec:
3ch
30mA Constant Current
12 to 24v operation OR
5V only

Parts cost are around 3.00 in PWB but exc the 24 to 5 SMPS. I haven't decided on the PS yet. AND you will need a DMX 2 SPI Bridge with RS422 driver capability.

So any thoughts?

Hi Matt,

Did you ever get this project running?
I stumbled upon your thread the other day, realizing you had the same idea that I have built:




My setup is driving high power LEDs using PWM and constant current drivers. It too utilizes a differential 422 comms setup to extend distance between devices, as we are using these as high power floods. The host body is a compact outdoor halogen floodlamp which I am fitting the heatsink and PCB into.


Reply
Page 7 / 8
Share: