Wireless serial mod...
 
Notifications
Clear all

Wireless serial modem

52 Posts
17 Users
0 Reactions
18.2 K Views
Posts: 21
(@tucsoncraig)
Eminent Member
Joined: 19 years ago

Hi RJ - Yes I understand they are two different animals, that's why I figured the xBee wouldn't work for me. What I was looking for is something that will implement full wireless dmx at 250k, just checking with you guys to see what your experience with those things was. At first glance, it looks to be a simple, transparent serial data solution but not at the data rates I would require.

Craig


Reply
nromanel
Posts: 147
(@nromanel)
Estimable Member
Joined: 19 years ago
scorpia wrote:FG,

from what im understanding your board is a simple RS232 - xbee board.
does this board do the same as your design?

check http://www.droids.it/data_sheets/990.006%20datasheet.pdf

might save some time

peter

Firegod, (Or anyone else)

Would these modules work the same as your design?
Would they work with a Ren24?

I don't quite understand the whole zero-cross issue... If anyone can enlighten me... that would be spectacular! 🙂


Reply
g2ktcf
Posts: 3651
(@g2ktcf)
Famed Member
Joined: 18 years ago

Nick,

As I understand it, the zero crossing signal is used in PWM to dim the lights. Basically, the power to the lights is controlled by turning the lights off and on during a certain time in the sinewave of the voltage (only needed for AC lights). In order to synchronize this timing, we need to know when the sinewave voltage changes from positive to negative (or reverse). This is called the ZC or Zero Cross point as the voltage actually becomes a value of 0 for a small period of time.

Hope this helps....

Chris


Reply
nromanel
Posts: 147
(@nromanel)
Estimable Member
Joined: 19 years ago

Thanks Chris!


Reply
omzig
Posts: 1603
(@omzig)
Noble Member
Joined: 19 years ago

What ever happened with this project? Did anyone ever get the Renard receiver to work?


Reply
Page 10 / 11
Share: