TucsonCraig
@tucsoncraig
Eminent Member
Joined: Apr 7, 2008
Topics: 3 / Replies: 18
Reply
RE: 8 Channel DMX board

And now Mr. aussiephil, that's eight and time for me to get away from people like you who are never wrong and never make mistakes. I don't need that. ...

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

Yes, i was worried about the cat5s ability as well. I was talking with Frank in Phoenix about that very thing. I know he has pushed cat5 to it's limit...

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

Nice job John!! What I am planning is close to that but there are new chips out that make things easier and more effecient. I am working with an A62...

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

DynamoBen wrote:Personally I’m thankful for the talent this forum attracts. I think your knowledge and talent can be an asset to the DIY community a...

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

Thanks TC. I wanted everyone here to have the same starting point that I worked with and thats why I included the link. The reason I developed the b...

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

aussiephil wrote:Craig If the optoisolators are not rotated as suggested by others then you are throwing away most of the reason for them being ther...

18 years ago
Forum
DMX
Reply
RE: Ok , so who's gonna brainstorm and build one ?

No RF, they output a calibration sequence to the display that you video and put back into the program. It then reconfigures output to match the curren...

18 years ago
Reply
RE: 8 Channel DMX board

P. Short wrote:As far as I know that part doesn't come in an SOIC package. The surface mount version of those parts is much larger than the typical SO...

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

I'm not sure if I agree with you guys on the need to rotate the optos. Think of this same optocoupler in an SOIC or such package. There is no way to g...

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

P. Short wrote:I'd add a thermal on pin 5 of the 485 chip. Am I correct in assuming that chip has built-in pullups (for the switch, in particular)? ...

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

That's better, Craig

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

Oh Boy did I mess up on the thermals on the caps. Better fix that. Craig

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

P. Short wrote:Incidently, I've never tried to deliberately run current through a heatsink. If you haven't done so already, you might want to see if t...

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

Yes, that makes sense on the low voltage stuff, I can change those to thermals to make soldering easier. I can also move some traces a little if you t...

18 years ago
Forum
DMX
Reply
RE: 8 Channel DMX board

n1ist wrote:The run from F1 to the triacs is mighty thin. Also, you may want to use thermals to connect component leads to shapes to make it easier to...

18 years ago
Forum
DMX
Page 1 / 2