I posted this on a blog but then decided I might get more suggestions if I post it in the forum.
I ran initial tests on my Servo SSR Replacement board. This is a board which can be used with controllers that use external SSR's by reprogramming the pic(s) with an updated Renard Servo firmware. I've updated the firmware to reset the outputs to the origional Renard outputs and allowing Negative outputs which will be needed for this board.
I only have 3 ic sockets so it's only a 3 channel board at the moment but in the end it will control 4 servos.
A couple updates are needed to make it easier to solder but for the most part is almost ready. I would appreciate and suggestions if you have them though.
I was hoping to make singing carolers this year but with a megatree on the way and needing to redo all the lights in my display I don't think I'll have time.
I've posted all files needed to create this board(if anyone is interested) in the File Library. Included in the zip file is everything you should need to self etch the board, some notes on getting it to work and the BOM. I don't expect to see a huge about of action for this so I don't see it ever getting to the point where getting the boards professionally done is warranted.
The updated Renard Servo Firmware has also been posted.
As with anything I put up there you are welcome to do with it what you want including making changes, improvements, etc. All that I ask is for you to post video's of your creations and that you have fun with it.
At this point I done a fair amount of bench testing with the firware and the board and I will be using this for my Halloween display this year(it's my guinea pig display).
Let me know if there are any questions/concerns.

