Somewhat Retro 4-Ch...
 
Notifications
Clear all

Somewhat Retro 4-Channel Controller

18 Posts
7 Users
0 Reactions
5,480 Views
Posts: 987
(@wirewrap)
Noble Member
Joined: 18 years ago

Looks great, Phil. Unless I miss my guess, the left outlet pair needs to be inverted to bring the "hot" connectors to the center of the board. At least that's what I think you're doing...

🙂


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago
WireWrap wrote:Looks great, Phil. Unless I miss my guess, the left outlet pair needs to be inverted to bring the "hot" connectors to the center of the board. At least that's what I think you're doing...

🙂

I'm planning on running the hot wires for the left set of receptacles from the left side of the board under the receptacle up to the connectors.


Reply
Posts: 987
(@wirewrap)
Noble Member
Joined: 18 years ago

Got it!

🙂


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

I ran the 8-Channel controller that I put in an 4-Gang box ( http://doityourselfchristmas.com/forums/showthread.php?12655-Renard-SSR8 ) this year. I had five of these chained at the end of a Ren-64. Once I got these working, they ran flawlessly but I learned a couple things.

Those outlets act as water drain holes and even if you cover the box with a bag, you have to make sure that the cords cannot act as water slides. It was difficult placing a bag around the box with 8 cords coming in from different directions, some being 3/8 inches and not wanting to be bent down at cold temperatures.

Also if water ran into the CAT-5 connectors, it ran down the mounting holes and onto the circuit board. Just so happened that the water sat between the rectified AC and ground and totally removed the trace. It still looked like it was there but no longer conducted. I found that on three boards.

All six boards (104 channels) were using my original full wave rectified supply with a 12 volt 150 mA transformer and because I used all incandescent's I used the original Renard with the pulsed TRIAC gate @ 19.2K baud. Not exactly fast but did the job with my limited setup time this year.

I'd still like to find some of the snap-in two prong outlets because I think the outlet boxes are still a bit big and stick out more than I really want.

I like your 4-channel board for it's simplicity and I'm interested to hear how this works in an actual outside environment.


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago

The weather here is a bit different than in Apple Valley. We've only had one day of precipitation since Thanksgiving, although there is often moisture on the ground in the mornings. There have been a few times at the beginning of the month when it froze overnight, but generally much warmer out. So results here may not translate very well.

I'm planning on mounting the boxes upright, with the power input and serial cables coming in from the bottom through the one hole in the box. It should be OK with a plastic bag over the box and drip-loops on the output cables.


Reply
Page 3 / 4
Share: