MOSFET gate resisto...
 
Notifications
Clear all

MOSFET gate resistor selection

2 Posts
2 Users
0 Reactions
2,567 Views
Posts: 789
Topic starter
(@chilloutdocdoc)
Prominent Member
Joined: 18 years ago
[#17839]

Trying to design an 8 channel DMX DC SMT dimming board and using the 771-PMV22EN215 MOSFET. To a guy doing his first design, it looks attractive (low Rds, small, relatively cheap, etc). I spent around an hour trying to figure out how to calculate the gate resistor, but I have a bigger headache after trying to understand what the documents were trying to explain. How do I calculate the gate resistor needed? I read some amount of balancing dv/dt and the power dissipated.

In short, it'll be driven by a 16f688 at 5V. Load will be anywhere from 100mA to 2A (not sure it will go that high, but the data sheet says it will)

I'll post a board layout and schematic when I finish it up.


1 Reply
David_AVD
Posts: 991
(@david-avd)
Noble Member
Joined: 17 years ago

Josh, I'd probably use a 47 Ohm gate resistor if it were me. I used 51 Ohms on the DC48 as we use that value for other boards.

I found that is gave the least amount of output ringing in my design when fed from the PCA96xx PWM chips.

EDIT:
Too high a value causes sluggish switching in the MOSFET which in turn causes losses as heat.

Too low a value doesn't dampen the ringing enough and can affect the output over the dimming range.


Reply
Share: