Sinewave Dimmer
 
Notifications
Clear all

Sinewave Dimmer

5 Posts
2 Users
0 Reactions
6,042 Views
mrpackethead
Posts: 2289
Topic starter
(@mrpackethead)
Famed Member
Joined: 19 years ago
[#2584]

The this thread is back alive!!! The attached PDF shows some different dimming methods, including forward and reverse phase control, and 'sine-wave' dimming, on page 3..


4 Replies
mrpackethead
Posts: 2289
Topic starter
(@mrpackethead)
Famed Member
Joined: 19 years ago

Possible cirucit..

I found this circuit in the propellor forum.. Looks pretty straight forward.. Providing the PWM signal will be a peice of cake.. its the power side that concerns me, as i don't have a through understanding of the topic.. Its not that far removed from what i had contemplated..

The pwm signal woudl be in the order of 50kHz, perhaps slower ( slower is good, igbts are cheaper )..

The SCR, Radj, Rshunt, are all about providing overcurrent protection..

The position of the bridge rectifier is ok for a single channel device but if you wanted to do multiple channels you'd need to modify the topology a bit, but thats not a biggy..

Anyone else care to comment.

sinewavedimmer perhaps

Reply
mrpackethead
Posts: 2289
Topic starter
(@mrpackethead)
Famed Member
Joined: 19 years ago

I've found a IGBT that might be a good starting point.. its a Fairchild semi HGT1S20N60A4S9A. Its a very fast device ( 200kHz ) meaning that if i use it at ~50khz, it won't be near its limits, at all. Short circuit protection will be really important.. they fry in 15uS if you short circuit them :-).. Not a job for a fuse.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

Wouldn't it be a bit better to define the problem first?

Searching for parts is good, but having an idea of cost points, how much power will be handled, what type of loads, how linear the response, and so forth would be good. Without this it would very hard for anyone to come up with useful comments.

--

Phil


Reply
mrpackethead
Posts: 2289
Topic starter
(@mrpackethead)
Famed Member
Joined: 19 years ago

Phil, you sound like a good engineer, whos wantingt to solve a problem. That is a great approach for many problems.

I don't so much have a 'problem', as a " I wonder what we could do with this "... Ie, i might come up with a solution, and then have to go looking for a solution.. So, it will be a case of, " heres some stuff and a rough idea of what i'm trying to do " and lets see what we can do with it.. So, i'm thinking i might start with this component and see what i can do with it.. If i get something working, then i could start looking at the problems and issues and look to see what i can do to improve it, or make it scale ( up or down ) to somethign that does work.

Whats a bit annoying is there does'nt seem to be many SPICE models for devices like this one or similar.. Simulating on screen could be many times simpler than on fibreglass and copper. ( watch out for the magic smoke poof! )


Reply
Share: