Simple Renard 32
 
Notifications
Clear all

Simple Renard 32

103 Posts
25 Users
0 Reactions
56.1 K Views
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Member
Joined: 17 years ago

I just updated the latest code in post #17 of this thread and in the DIYC file library...:)
why??,,, I sent the wrong one before...:mad::confused:


Reply
tstraub
Posts: 525
(@tstraub)
Honorable Member
Joined: 18 years ago

I am currently making a some changes to the board layout on the Simple Renard 32. The biggest change I will be making is relocating the voltage regulator. The current design worked well while I was using a PICkit 2 clone to flash the PIC. I recently purchased a PICkit 3 and discovered that the voltage regulator is too close to the ICSP header and makes it difficult to plug the PICkit directly to the header so It needs to be moved. This dose not cause any problems once the PIC is programed but I would like to change it for for production boards.

I see that the etch files for this board have been downloaded just over 30 times since I added them to the File Library a few months ago. So I would like some feed back. If anyone has built this board please let me know how it worked out for you. If there are any other changes that should be made please let me know. Thank you.

Tyler


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Tyler,

The board worked fine for me. I connect to the ICSP header via a ribbon cable so for me, there is no conflict with the regulator.


Reply
steve_hirst
Posts: 296
(@steve-hirst)
Reputable Member
Joined: 17 years ago

same here, no problems


Reply
N7XG
Posts: 480
 N7XG
Guest
(@n7xg)
Member
Joined: 19 years ago

Earnie,

Did you ever get this project completed? It sounds like you had some good ideas. I would also like to see pictures of the completed board.

Dean, N7XG


Reply
Page 6 / 21
Share: