Simple Renard 32
 
Notifications
Clear all

Simple Renard 32

103 Posts
25 Users
0 Reactions
56.1 K Views
tstraub
Posts: 525
(@tstraub)
Honorable Member
Joined: 18 years ago

That sounds great Mac. I just took a look at the schematic and I think I have all of the parts required to build one 🙂


Reply
tstraub
Posts: 525
(@tstraub)
Honorable Member
Joined: 18 years ago

Working from Mac's schematic I have come up with a home etched version of the Simple 32. Its only ran for about an hour but so far it looks very promising. Component placement is tight in places but the board dose retain the same 3x4 inch footprint as the 24 channel version. Here are some pics for all to enjoy. Honestly the solder joints look lots better in person the camera flash really makes the left over flux look terrible.
Tyler

DSCF0996 (Small)

DSCF0997 (Small)

Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

I'd recommend putting a .1µF next to both supply inputs on the micro. Based on my noise testing at work, just one cap would be too far away to be effective (for both supply surges and noise immunity).


Reply
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago
tstraub wrote:Working from Mac's schematic I have come up with a home etched version of the Simple 32. Its only ran for about an hour but so far it looks very promising. Component placement is tight in places but the board dose retain the same 3x4 inch footprint as the 24 channel version. Here are some pics for all to enjoy. Honestly the solder joints look lots better in person the camera flash really makes the left over flux look terrible.
Tyler

Very nice job Tyler, I would also go along with Ernie's suggestion on the extra cap on the PCB for noise reduction, I am going to add to the schematic. I should post the final code sometime this week, it is pretty much the same as what I sent you except for some small changes.


Reply
tstraub
Posts: 525
(@tstraub)
Honorable Member
Joined: 18 years ago

Ok I'll add the cap. Looks like there is plenty of room to just drill the holes in the pcb then bend the leads over to the PIC on this one. I'll add traces and pads for any future boards.
Tyler


Reply
Page 2 / 21
Share: