Renard-WC Wireless ...
 
Notifications
Clear all

Renard-WC Wireless Controller

266 Posts
47 Users
0 Reactions
119.2 K Views
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

Thanks. That's actually quite a lot for what I was looking at - I was hoping that it would be down around 5mA or lower for a controller that I'm working on.


Reply
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

With apologies to Phil, I am shocked.... SHOCKED I say....

I've actually never measured the current draw of a Ren-W, and all my calculations were based on spec sheets. I've had a couple other requests for this information, so I took some gear and tested it in an actual live-case. Here are the results (maximim values) in RECEIVE mode:

The Ren-W Rev6 board by itself, without an XBee module installed draws 52.8ma

The Rev6 board with a regular XBee radio installed draws 99.9ma, meaning the regular Xbee alone draws an additional 47.1ma

*** The Rev6 board with an XBee Pro radio installed draws 103.1ma, meaning the XBee Pro alone draws an additional 50.3ma

Because the Rev6 has an LED on board, you could remove it and save yourself about 10-15ma; it's not a required part.

I learned an important thing today: don't trust the manufacturers' spec sheets.


Reply
Posts: 34
 rodb
(@rodb)
Eminent Member
Joined: 16 years ago

Given the size of the current draw I would start looking for conflicting GPIO pins. I have worked in mobile multi-media and sometimes when current draw is this far off you have a pin that is trying to drive high while being pulled low (or the other way around).

I will freely admit that I don't know the HW you are talking about and that this could be the current draw but often it is worth double checking the schematic.


Reply
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago

Thanks again Dave, for doing this research.

rodb wrote:Given the size of the current draw I would start looking for conflicting GPIO pins. I have worked in mobile multi-media and sometimes when current draw is this far off you have a pin that is trying to drive high while being pulled low (or the other way around).

I will freely admit that I don't know the HW you are talking about and that this could be the current draw but often it is worth double checking the schematic.

The wiki is your friend: Ren-W

(Or you could read the OP...)


Reply
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Here's something new on the scene, it's a plug-in replacement for the XBee that turns your Ren-W into Wi-Fi compatible, configurable with TCP/IP, DHCP, and everything Wi-Fi. I've got a couple on order to try them out... The data sheet says the UART can handle up to 464kbps, so I'm doubting it's still fast enough for DMX... but.... it may be worth a try, who knows??? Downside? A couple bucks more than the XBPro module and so far, the only antenna option is an on-board mini-whip. The product is called the RN-XV from Roving Networks.

A couple links for you to get more info...

http://www.mouser.com/Search/ProductDetail.aspx?qs=7nsJMBTpJlzTBgzSFkpUYQ%3D%3D

http://www.sparkfun.com/products/10822

RN XV W

Reply
Page 49 / 54
Share: