Renard-WC Wireless ...
 
Notifications
Clear all

Renard-WC Wireless Controller

266 Posts
47 Users
0 Reactions
119.2 K Views
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

With nothing in-between, direct line-of-sight using high-gain external antennas on the XBee Pro radios, tweist said he got about 2 miles. I've found I can easily get about 1000 feet from the transmitter in the front of my house using 9db gain antennas on both the transmitter and receiver; after that, I run into obstructions and have to go down a hill making the test invalid.

The XBee spec states 1 mile, but bear in mind that's under optimum conditions and not running a streaming protocol at 57600 baud which we need for blinky-flashy.

Tweist said he had problems with trees that had leaves. I can believe it. I was dinging around this fall and discovered that a large evergreen soaks up the transmission like you can't believe -- so I put the controller on the transmitter-side of the tree instead of the other side. So simple things like pine needles (and lots of them) that can have an amazing effect on the radio waves.


Reply
DaveJZ
Posts: 974
(@davejz)
Noble Member
Joined: 16 years ago

Thanks Dirk I would guess I'd have to go about 300ft.. maybe 400ft. So
I may be able to pull this off for them...


Reply
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
DaveJZ wrote:Thanks Dirk I would guess I'd have to go about 300ft.. maybe 400ft. So
I may be able to pull this off for them...

Glad to help, Dave my man!

tweist is DIYC's resident expert in doing a neighborhood or just multiple houses with wireless blinky-flashy. He's got it all worked out and would be a good one to contact with specific questions.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

Just out of curiosity, how much current do the Ren-W controllers draw while in receive mode? I should look it up, but am too distracted at the moment.


Reply
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

It's quite minimal. In standby it's really tiny, but receive is about 40-50ma. The max232 takes about 8ma and the xbee pro is around 38.


Reply
Page 48 / 54
Share: