Renard Pixel String...
 
Notifications
Clear all

Renard Pixel String Controller

258 Posts
50 Users
0 Reactions
121.7 K Views
boyelroy11
Posts: 757
(@boyelroy11)
Prominent Member
Joined: 17 years ago

It is possible that the programming utility you're using has the group size and group count switched. You might reverse your 1 and your 50 and see what it does.


Reply
Posts: 17
(@comicrcc)
Active Member
Joined: 12 years ago

They are changing colors per the effect just all together. If one is red all are red etc.


Reply
Posts: 17
(@comicrcc)
Active Member
Joined: 12 years ago

The lights will change per the effect just all together. One red all red.


Reply
boyelroy11
Posts: 757
(@boyelroy11)
Prominent Member
Joined: 17 years ago

It sounds like the PX-1 is programmed as a group of 50 pixels, rather than 50 individual. That's why I suggested swapping the 1 and 50 in the programming utility to see what it does.


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

what is the 8:1 in xlights start ch should be like 3583


Reply
Posts: 17
(@comicrcc)
Active Member
Joined: 12 years ago

I tried switching the 50 & 1 and no change. The 8 is the controller # in the setup list.


Reply
Posts: 17
(@comicrcc)
Active Member
Joined: 12 years ago

Yes the preview is fine.


Reply
Posts: 17
(@comicrcc)
Active Member
Joined: 12 years ago

I finally found the problem. I use James Bolding's PX1 programming utility and no where did I see you have to put JP4 on when programming. With or without the jumper the program says all is OK but it is not unless the jumper is on. Now they work like a charm. Thanks everyone for all the help.


Reply
Page 26 / 26
Share: