One-Channel Control...
 
Notifications
Clear all

One-Channel Controller

99 Posts
21 Users
0 Reactions
38.8 K Views
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago

How far from the computer can you get with CMOS levels?
And will this require a new plug-in in Vixen or will the current Renard plug-in still work?


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago
Jrd wrote:How far from the computer can you get with CMOS levels?
And will this require a new plug-in in Vixen or will the current Renard plug-in still work?

I'm planning on using RS232 for the first link, and then converting to the CMOS levels near the first node. The zero-crossing signal and DC power will also be generated at the point of RS232-CMOS conversion.

It will need a new plugin, which already been written. It has not been included in the standard Vixen releases, though.

As usual, all of this is subject to change. Especially if someone comes up with a better method.


Reply
Posts: 789
(@chilloutdocdoc)
Prominent Member
Joined: 18 years ago

Very great idea, any idea what it'd cost? I could see a major use for this.


Reply
Braveit1
Posts: 577
(@braveit1)
Honorable Member
Joined: 19 years ago

I frequently have to "remote into" a computer at work when I am out of the office. The computer has an external hard drive attached to it that must be on in order to access it. If I leave it on all the time it shortens the life of the drive because most external cases do not spin the drives down when idle. If I turn it off I have to come into the office to access the dive. A single channel A/C powered controller over USB would let me turn on and off the drive remotely. And if you could dasy-chain controllers I could add additional drives while keeping the overall footprint small. I know I could use the parallel port and a solid state relay to do the same thing but newer workstations don't even have parallel ports in them. Looking forward to your solution/controller.


Reply
IaRoadKill
Posts: 586
(@iaroadkill)
Honorable Member
Joined: 12 years ago

Did anything ever become of this?


Reply
Page 5 / 20
Share: