One-Channel Control...
 
Notifications
Clear all

One-Channel Controller

99 Posts
21 Users
0 Reactions
38.8 K Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago
Jrd wrote:I can see how that could be helpful for some people.

So this controller would have an on-board ssr/triac, makes sense for only being one channel. And you should be able to daisy chain 1150 of these together with a baud rate of 115200 and a refresh interval of 100ms. That would be much better per Cat5 than the channel selectable ssr's four per Cat5.

Will these communicate with RS232 or RS485?

I don't really envision it becoming this big, partly for cost reasons. I think that something like the Renard-16, Ren-24 or Ren-SS series would be better for displays with this many nodes. I'm thinking of this more for use in special circumstances where these heavy-weight controllers aren't a good fit (for weight, cabling reasons, etc).

As mentioned before, the version that I'm currently planning on using myself will have CMOS levels (neither RS232 nor RS485), and is limited to 38400 baud (no more, no less). But there is nothing that says that someone else couldn't do a version with RS485 drivers, or creating some other design that doesn't have these limitations.


Reply
Posts: 136
(@j1sys)
Estimable Member
Joined: 17 years ago

Phil -

Very tight coding or am i missing something.

38400bps = 26usec per bit

4mhz/4 = 1usec per operation = 26operation per bit sampling period with NO oversampling. plus you have to add pwm and protocol overhead.

congratulations!!

-Ed


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago

You are not missing anything, and that is why it is limited to 38400 baud. There are parts that run at twice the speed (PIC10F22x, PIC12F510) that are little bit more expensive, but I didn't need to use them here.


Reply
Posts: 25
(@lumax)
Eminent Member
Joined: 18 years ago

Just an Idea here...

something like an X10 receiver would be really nice... control data is sent in the power line wire, so no need of a data cable... this would be perfect for a single channel controller !!!

There is also the industrial version of the X10 they call it DIMONOFF made in Quebec Canada!


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago

X10 is way too slow for this...perhaps good for a total of one channel if you are lucky.


Reply
Page 4 / 20
Share: