Unless you are only using a couple of these, you don't want to use the straight PIC output from the 16F688 to enable these. The LV mentioned above will work but can be hard to find these days - you can build your own fairly easy and if using DMX or slow serial (like 19.2K) you can get away w/o the crystal to make it cheaper. You can use the Ren48LSD as well for this (it's what I use...).
I use the Ren48LSD for mine. Works great!
I use a ren4flood with 5v input modification ( http://www.doityourselfchristmas.com/wiki/images/f/f3/Ren4Flood-v1c.pdf ).
Gives me 4 channels (zones) and handles the small number of FAST tubes I run.
A lot of people running FAST tubes do not try to control them individually, rather they program the chips with different start times and fall rates (all configurable when you flash the chips) and then they simply run a small 5V PS, or wall wart plugged into a single channel on their AC controller. They look like they are random, yet only use 1 channel for control.
TomL8345 wrote:A lot of people running FAST tubes do not try to control them individually, rather they program the chips with different start times and fall rates (all configurable when you flash the chips) and then they simply run a small 5V PS, or wall wart plugged into a single channel on their AC controller. They look like they are random, yet only use 1 channel for control.
This is very true and makes good sense. So of course I didn't do it that way. Mine are along the eves. 6 tubes on each cat5 (6 control wires and 2 common). 4 cat5 to a Ren48lsd. So I'm only using 24 channels of the 48. And one 5v 350w supply. So I have individual control but barely use it. So I have spare channels and power for something else, housed in one cg1500.

