Ignorant question.
Can these be run via DMX?
Thanks,
Qbert-PNS wrote:Ignorant question.Can these be run via DMX?
There are no ignorant questions (nor "stupid" ones either).
This project for DMX morphed into LEDancer (see this thread).
Todd at DIY LED Express has carried this FAST and LEDancer kits in past years (though the segments currently seem to be sold out).
HTH.
\dmc
I was just aknolging I didn't know.
I'm good with ignorant. That's how I become non-ignorant.
Stupid is not asking the question.
Have a great night. Thanks/
I'm curious what everyone is using to provide power to these? Are you using the output from the Renard LSD (or other) board?
Here's my scenario: I'm running a full A/C show off a combination of Renard SS boards. I would like to add these into my show on a channel off my current boards. I guess my best solution is to put an AC -> DC5V transformer on each one of these so that I can wire it straight into my current A/C show. So, if I go with this route (if that's even the best way to go), are there any recommendations for stepping 120AC down to 5VDC? I've seen cheap ones from china like this one http://www.aliexpress.com/item/2pcs-lot-220-V-to-12-V-to-5v-to3-3V-AC-DC-power-supply-module/1719085335.html (no clue how long that link will stay around - it's a very cheap 90-260VAC in 5VDC out), but obviously at $4, these are unregulated. I could build a regulated supply, but I'm trying to keep my costs down. I guess without a data sheet or one to test, there's no way to know how high above 5V these might spike. If I'm not mistaken the PIC16F688 can handle up to 5.5v. So, anyone out there have any ideas or recommendations?
airsouth wrote:I'm curious what everyone is using to provide power to these? ..... If I'm not mistaken the PIC16F688 can handle up to 5.5v. So, anyone out there have any ideas or recommendations?
There are several ways to accomplish getting 5 volts to the board. You could use a Wall Wart to do it, or a small 5 volt power supply, but I plan on using a couple of buck converters running off of a Renard 24 LV to provide the power. The WIKI says that each one only draws 30 mA of current. Remember, these are only on or off, there is no fading (pwm). So all you have to do is get 5 volts to the board.
