tjetzer wrote:Why use two 2 wire connectors when you can use one 4 wire connector? Use the 4 wires to connect to the FAST controller in a "Y" configuration and use the 4 wires on the other side of the connector to split in and out.
The setup I mentioned only used one 2 wire connector per tube just as the 4 wire one does.
Anyways, your idea is also another great configuration. If I understand you correctly, it mimics the "T" connector shown in post #308
It really comes down to personal preference... Using the 4 wire connector allows you to have one "main" run of 5V power, while the 2 wire connector lets you daisy chain many tubes off each other.
AND if you really wanted to show off, you could do a combination and have a large spider web network of fast tubes using both configurations!
I just used some old mini light wire for the power run and spliced in the tube where needed, soldered and srink tube. Easy.
I used lengths of Cat5 stripped back about 3-4' and ran the individual pairs to a FAST and then tied the other end back to the supplies. In my case I used a single Ren48LSD channel but you can do many on one channel if you want. This gave me a bit more control over them and I had extra channels. Cat5 and heat shrink is about as cheap as you can get - inter-connectors = $$ so I try to stay away from them. I just wrap the four FAST together with the Cat5 and store them away.
budude wrote:I used lengths of Cat5 stripped back about 3-4' and ran the individual pairs to a FAST and then tied the other end back to the supplies. In my case I used a single Ren48LSD channel but you can do many on one channel if you want. This gave me a bit more control over them and I had extra channels. Cat5 and heat shrink is about as cheap as you can get - inter-connectors = $$ so I try to stay away from them. I just wrap the four FAST together with the Cat5 and store them away.
+1
This is how I am going to do it as well. Or close....I am planning on 1 LSD port for 4 FASTs. I only have 9 FASTs in my display this year. I plan on daisy chaining two together, so I am only using two LSD ports to fire my FASTs.
Steve E.
I read through this thread and can't find the answer to my problem however it may be the number of LED's I am using with the original firmware.
The asm. file and code writing is a "little above my pay grade" 😛
I have two FAST strips with 14 LED's each for a total of 28 per controller. All the LED's light with the original and DIAG firmware. I have checked all my solder connections.
The problem is after powering up, LED #6 and #12 on strip one and LED #4 and #10 light sooner and hold on longer then the other LED's during the sequence. Not a big deal but...
Can someone provide me with a hex file so i do not have to figure it out for myself. :blush:
Thank you for a GREAT item.
