I've been working on an idea for inexpensive snowfall tubes.. What I've come up with so far consists of :
1-PIC 16F688
8-51Ohm 1/8Watt Resistors
1-10KOhm 1/8Watt Resistor
56-Pure White SuperFlux LEDs (Or Any LED, Depending on Vf the 8 resistors value might need to change)
My plan is not to create a PCB for these but take strips of white Formica and drill the holes for components. I know tedious but the idea is inexpensive and I've got time.
My plan is to power 1 tube per Ren48LSD Channel. Simply supply 5V to the tubes and they do a "fall".. I've written some Firmware for the PIC. I have 2 working versions. One is straight forward and loops through 28 times lighting 2 LED's each time through the loop with delays. The second is a variation with a TMR0 interrupt triggering the next run though the loop. Both Firmwares start with the fall going fast and then slowing as it "falls" I'm attaching the Schematic & Firmware for what I have currently working. Ideally I'd like to get it to a point where there are a few configurable options in the firmware such as setting a flag for maybe a "dimming tail" or other ideas. I'd like some input on the software and if possible some help with the code. I'm 1 week into learning assembly, so I know I've got a ways to go.
Here is a video of the LED's on my breadboard..
(Uploaded at 11pm on 4-18-11.. Vimeo says it might take til midnight to convert. If it doesn't work try back)
Very cool. Can't wait to see the finished product and total cost as well.
Your timing stinks... 🙂 About the time you were waiting for the Video to upload and convert, I was finishing my Taxes and beginning to pull out all my Blinky Flashy stuff. I told myself that I had to get my Taxes done before working on my two new projects: RGB Sparkle Balls and Snow Fall tubes. My tubes were based on BobKeyes design. very similar to yours, but a simple 12 LED solution driven directly off the PIC.
I like the formica idea. For my My prototype I cut a strip of a piece pegboard and pushed the LEDs from the back.
Did you write your code from Scratch? I'm very impressed. Not sure I coudl handle the Matrix stuff.
If you haven't seen it, here's the post where Bob's starts:
http://doityourselfchristmas.com/forums/showthread.php?5870-Falling-snow-lights&p=107970#post107970
No matter what happens, I think most of the DIY designs could use this type of LED. Where did you get yours and what was the cost? Do you think it makes sense to do a Bulk Grup Buy? I struggle at pulling the trigger on LED purchases. I'm never sure on what I'm buying. I have been using a bunch of LEDs that were sold as replacement for LED strings. I bought every replacment pack the 3 Walmarts near me had for like .15 per pack of 5. They are not as bright as any LED I have seen in a tube, and have strange viewing angles, so I would like to use something different.
Very nice. I have been investigating this same type of design, but never finished. I really like the idea and have looked online at some of the pre-made units but did not like the way they were triggered.
I would gladly be up for a group buy on this one. What length are you thinking of obtaining? And to be able to trigger it from Vixen is the best part.
Please keep me informed.
Now that I had a chance to look at the Schematic, my brain hurts. It looked like a matrix of some kind, but when I look at the mixed orientation of the LEDs, I don't see it. Can you explain the concept? Sorry, I'm a bit dense.

