ENC28J60 Controller...
 
Notifications
Clear all

ENC28J60 Controller Questions

11 Posts
5 Users
0 Reactions
4,561 Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago
Barnabybear wrote:Hi, I had a play with the ENC28J60 and a Arduino Nano. It worked well outputting DMX and WS281x Pixel I've linked my ramblings below, the first 27 post relate to W5100 but on post 28 it swaps to the ENC.

https://diychristmas.org/vb5/node/8467

What Ethernet controller is that?


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago
Reply
A Marchini
Posts: 426
(@a-marchini)
Reputable Member
Joined: 19 years ago
P. Short wrote:. Would it be better to split the ground plane, with just a narrow trace between the logic portion of the board and the LAN connector of the board? Bear in mind that I'm not going for any sort of standards conformance, just for a board that is reasonably clean for EMI/EMC purposes.

Maybe try out their design check service, see if they have any suggestions? https://www.microchip.com/en-us/support/design-help/design-check-services
P.S. I am a little surprised they don't have a layout guidance document. Maybe at these speeds , it just doesn't matter.


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago

Considering how inexpensive those Ethernet shields are, there is no point in my continuing with my design. For what I want it would be better just to design a processor board to the nano pinout.


Reply
Barnabybear
Posts: 1583
(@barnabybear)
Noble Member
Joined: 15 years ago

Hi Phil, if you get chance to share your findings on the initial setup of the control registers and Ethernet buffer of the ENC28J60 I would appreciate it. It was my intention to look deeper into the data sheet to find out how these worked to best utilise the buffer but finding a working library and running short on time meant this never happened.


Reply
Page 2 / 3
Share: