DMX2REN design
 
Notifications
Clear all

DMX2REN design

56 Posts
14 Users
0 Reactions
23.3 K Views
dirknerkle
Posts: 10309
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Thanks, Brian! You're the best! 😎

-dave


Reply
Macrosill
Posts: 9739
Topic starter
(@macrosill)
Member
Joined: 19 years ago

My pleasure. Thanks for catching me on this one. I hate it when I read threads and they end result is never posted.


Reply
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago

Great design Brian, but how do you keep the Renards from using the same channels over and over again? I do not remember the Renard DMX firmware being addressable.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
Jrd wrote:Great design Brian, but how do you keep the Renards from using the same channels over and over again? I do not remember the Renard DMX firmware being addressable.

The DMX code is addressible - it defaults to '1' - I haven't had a need to use that yet but it will probably come up sooner or later - especially if something wireless comes up for it.


Reply
Macrosill
Posts: 9739
Topic starter
(@macrosill)
Member
Joined: 19 years ago

Pic code addressing. Each Ren64 board is addressed. The board with channels 1-64 gets all the pics programmed with a start address of 1. The board with channels 65-128 gets the 1st pic programmed with the start address of 65 and the rest of the pics on the board get programmed with a start address of 1. The board with channels 129-192 would get the 1st pic programmed with a start address of 129 and the rest in the board would get a start address of 1. Then so on and so forth. Only the 1st pic on the board gets a start address, every other pic gets a start address of 1.

You can have 2 controllers do the exact same thing by addressing them with the same start address.

Here is the line in the code:

#define DMX_START_ADDRESS 1

I believe it is line 53.


Reply
Page 11 / 12
Share: