DIGWDF WiFi SSR
 
Notifications
Clear all

DIGWDF WiFi SSR

9 Posts
3 Users
0 Reactions
5,688 Views
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago
[#53140]

Editing to not start a new thread.

I have a voltage issue on this board. When I do the voltage checks according to the assembly instructions, I'm getting 3.3v where I should be getting 5v. And, I'm getting around 8v where I should be getting 3.3v. This is a freshly built board, but a component could have been bad. Which item should I replace or check further?

What firmware is used to flash 16f1825 chip to run the ssrez? I've tried the PMW for channel 1, but it only turns on channel one. Should I be using different firmware?


8 Replies
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago

NM. Duh


Reply
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago

Replying to bump with a new issue.


Reply
Posts: 999
(@ppohlman)
Noble Member
Joined: 19 years ago

You shouldn't have anything over 5V on the board. If you're getting 8V anywhere, I would check the power buck to make sure you're getting 5V out of it.


Reply
Posts: 182
 slug
Topic starter
(@slug)
Reputable Member
Joined: 19 years ago

Nope. Getting 3.3v now. I must have messed something up. I'll throw a different one on in the morning. Thank you


Reply
Page 1 / 2
Share: