awhaley wrote:I guess that's evidence of your good work too! Charlieplexing diagrams usually look so complicated! The fact that you make it look simple enough that the ignorant (me) confused it with simple multiplexing is impressive. 🙂
Actually, it was Phil's post in another thread (but I can't find it now) that redrew the charlieplexing as a row/column matrix.
don
If you make it not look like a mess to wire, it starts to look legit. 😉 I still think the name 'charlieplexing' makes it sound too much like something your uncle charlie cooked up on a napkin... but... 😉
I'm torn on using the charlieplexing for this partiular application though... It cuts down on the number of ICs... but greatly increases the number of wires running from each one of them and I'm not sure that bundles of cat-5 coming off and then wires splitting out here and there makes for a pretty icicle curtain device... at least when compared to one IC every two or three icicles with fewer wires coming out. But it's hard to beat the cost and efficiency of getting 56 individually controlled pixels off on 16f688... so, like I said. Definitely torn.
Art
As I see it, the wiring complexity is more or less the same in both cases. For charlie-plexing in the eight-output situation the wiring would be more or less as depicted in djulien's drawing above. It would be eight wires (like perhaps a CAT5 cable) leading off from the controller. Then, for each side-strand, there is a tap taking a small number of wires down that side-strand. The number of wires that are tapped off depends on how many lights there are on the sub-strand, I would think it could be as few as three wires if there are three or six lights in the sub-strand.
I think I opened a can of worms with this one 😉 But if it does come to fruit, it will be worth the effort. I envision using as many as ~200 strings on my house so if I can be of any help, I’m in.
I also have little idea how charlie-plexing works, so I’m confused on how this will work out in the end. I’ll google charlie-plexing and learn more when I have more time.
I personally like the idea of varying sizes of light strings. I’d prefer it to be random or user selectable as to the length of each string would be though.
This idea is doable most of the work is in the wiring I have something similar the bench now using the original ledtriks panel wiring.
My prototype has 8 leds per drop using 9 wires …8 anode wires daisy chain to the next 8 leds the full length of the 48 icicles string the 9th wire is the cathode witch runs the full length of the string from each icicle to the controller on the end .
If I ever complete this, the finished string would be 48 ft long using 6 inch spacing between the icicles or 2 strings at 24 foot each. Syncing them to music isn’t possible with the controller so I put this on the back burner with hopes a new controller would come along.
Also my setup only used one color possible to use bi-color to get 2 but would cut the string length in half
