Notifications
Clear all

Hattitude

3 Posts
2 Users
1 Reactions
11 K Views
rayhjr
Posts: 973
Topic starter
(@rayhjr)
Noble Member
Joined: 12 years ago
[#58554]

Well here it is a year latter after my friend Dave gave me a prop called Hattitude and I'm just now starting to push 700 pixels and get it ready for this years show. I just wanted to ask advice from anyone who has one or has a large Coro Pixel prop about handling it. I plan to replace 3 singing bulbs with this prop. It will hanging from a beam across the front of my Poarch. We have various sizes of hooks screwed up into the beam for the wife's hanging baskets so it will be hanging from a sturdy place. I could even rig up a stand from the deck, or hand rail, to help firm up support.
The advertised brackets look like a god way to support and possibly hang the prop, but at 50 bucks plus, there has to be something cheaper, something I could rigg up myself to get the same results. Any Ideas? What do you use? How do you Hang Large heavy props? It's 46" diameter and just shy of 700 pixels. Hattitude. Thanks in advance.


2 Replies
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

As our Hattitudes are free standing, my suggestions don't seem to fit your setup. Just in case, we created rings just smaller than the main part of them (we have two) and then using 3 inch spacers and 1/4" lag bolts connected the coro to the ring. A cross bar on the ring is how we hang them on a tripod like stand. This is all done because our display is in a valley in our park and that very valley is a wind-tunnel. They have been standing now for several years without a problem.

FYI - The lag bolts (x4) pierce the 10mm coro, then a larger washer against the back side of the coro with a piece of pipe (as a spacer) and finally thru the ring. Washers and lock nuts hold it all to the ring.

A bit of overkill for most, but it fits for our situation.


Reply
rayhjr
Posts: 973
Topic starter
(@rayhjr)
Noble Member
Joined: 12 years ago

Since it was slit down the back and folded in half for shipping, I knew I wanted something to reinforce it. I had 2 pieces of aluminum unistrut laying around, 1 thin and 1 thick. I had some 3/8" all thread, had to buy finder washers and nuts.
Thin piece cut in half was long enough to give me 2 - 24" pieces to bolt top to bottom. Thick strut cut in half reached side to side, 32" I believe.
At some point I may replace the side pieces with longer pieces so they extend down past bottom of prop so I can stand it or prop it up and not have coro touch the floor. Being aluminum it did not add much weight and will give me options for hanging. I may still have to attach something to the middle, we'll see.

20250221 090613
20250221 090649
20250221 090704

Reply
Share: