aesl1982 wrote:Any way to figure out the direction data flows?
No, but that's a good point. My measurements are only valid on the input side of the strand.
If you have a strand that you simultaneously don't know the data direction or the pinout, then I'm not sure.
There is probably a way to tell it using Diode Forward Voltage, but I haven't tested that and wouldn't want to test it quickly on just one strand type.
On the 0.6V/1.6V thing I've tested on ~6 different types. It's pretty reliable. I've now identified about a 100 strings only using that mechanism. (I had Ray make all my strings with 6 ft of extra wiring on the input side, but it's all black/all white so it gets a bit painful to trace by hand over that distance).
deonb wrote:No, but that's a good point. My measurements are only valid on the input side of the strand.If you have a strand that you simultaneously don't know the data direction or the pinout, then I'm not sure.
There is probably a way to tell it using Diode Forward Voltage, but I haven't tested that and wouldn't want to test it quickly on just one strand type.
On the 0.6V/1.6V thing I've tested on ~6 different types. It's pretty reliable. I've now identified about a 100 strings only using that mechanism. (I had Ray make all my strings with 6 ft of extra wiring on the input side, but it's all black/all white so it gets a bit painful to trace by hand over that distance).
Oh ok. Hos drawing he sent showed pinout so that should be data out then. The ones from ray Wu are just bare wire each end.
Sent from my iPhone using Tapatalk
