Cascade Failure?
 
Notifications
Clear all

Cascade Failure?

6 Posts
5 Users
0 Reactions
4,825 Views
Posts: 2
Topic starter
(@maddogmike)
New Member
Joined: 13 years ago
[#29625]

So, I have a pre-lit tree with GE incandescent bulbs. Probably only used it for 2 or 3 Christmases, though it sat in the attic for a few years unused until this year. Anyway, everything lit up OK this year initially. Later I noticed a couple of spans of lights were out. I noticed several bulbs in those spans were obviously burned out - blackened on the insides. Started replacing bulbs, probably replaced about 70 in one span. No go. Went and bought the LightKeeper Pro, but no luck with the click-to-repair (shunt repair).

Now, the LKP manual says, "Numerous blackened bulbs imply a light set that is at the end of its useful life." Also, Land O Lights describes this as a "cascade failure," and also advises to throw away the set.

Now, I can understand how a cascade failure can cause the domino effect of burning out bulbs. But why would that make the set itself bad? Can't I just replace all of the burned out bulbs?


5 Replies
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago

As long as all of the wiring is in good shape, there is no reason you couldn't. Just make sure all of the bulbs are of the correct voltage for the string.


Reply
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 20 years ago

I ran into a similar issue when putting up my tree in the livingroom. I had a set of lights where all the bulbs were blackened. I hit the set with the LKP and it turned on. Nuerous bulbs were out so I started changing them. Bulb after bulbs that I changed would burn out immediately. They were the proper voltage. All 50 ct sets. After the fourth bulb I gave up. At 2 bucks per string it was not worth my time to figure out what was wrong.

If your string is integrated into the tree then you may have th change all the bulbs, with the power off. This will prevent any new bulbs from taking a shot of higher then expected voltages in the even lots of those bulbs are burned out and the shunt is activated. I am assuming that is what was happening to me.


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

When a bulb burns out, the shunt shorts the bulb. This will raise the voltage across all of the other bulbs. The more burned-out bulbs, the higher the voltage across the remaining good bulbs, and the shorter their life will be. Don't let more than a few bulbs go out or they all will burn out.
/mike


Reply
Posts: 2
Topic starter
(@maddogmike)
New Member
Joined: 13 years ago
n1ist wrote:When a bulb burns out, the shunt shorts the bulb. This will raise the voltage across all of the other bulbs. The more burned-out bulbs, the higher the voltage across the remaining good bulbs, and the shorter their life will be. Don't let more than a few bulbs go out or they all will burn out.
/mike

Yeah, I understand that. What I don't get is why those two sources say that would necessitate throwing out the set. It's just burned out bulbs, not like it would affect the wiring or sockets, right?


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

The wiring and sockets would be fine. Depending on what the lights are on, it just may be easier to replace the whole string than move all the bulbs over. On others, like arches or wireframes, it is probably easier to buy a new string and move the bulbs over.
/mike


Reply
Share: