Notifications
Clear all

12v pixels

23 Posts
12 Users
0 Reactions
11.7 K Views
Posts: 118
Topic starter
(@pjones)
Estimable Member
Joined: 11 years ago
[#40421]

So how I understand it is that 12V pixel chips control three LED's (three groups of RGB LED's) at a time where as 5V pixel chips can control each LED individually.

My question is this: Are there 12V pixel chips that can control each LED individually similar to the 5V strands? I would like to use 12V because of the increased length that the strands can be run and additional pixels that can be supported before requiring power injection. I just haven't found a clear answer on this yet.

Thanks.

Sent from my iPhone using Tapatalk
*Updated to fix terminology and clarify*


22 Replies
Posts: 274
(@kartingted)
Reputable Member
Joined: 13 years ago

Are you taking about nodes or strips?
For bullet nodes each one is controlled separate and can be 12v
For the strips I have now seen a 12v strip where you can control each led seperate.
Like I said I have not seen them but someone with more expirence might just in too


Reply
Posts: 535
(@mharnish)
Honorable Member
Joined: 12 years ago

The voltage does not effect how many pixels are controlled at one time. You can get 5V or 12V pixel strips or strings and have full control over every pixel. I used all 12V last year as you can get longer runs without having to do power injection than you can with 5V. I can usually get 100 pixels, each individually controllable, from one port of my e682 controller before having to inject power.


Reply
Posts: 118
Topic starter
(@pjones)
Estimable Member
Joined: 11 years ago

Ideally both bullets and strips. To keep layout simple I would ideally like to stick with one voltage for all my pixels as I build my setup. For now I am looking at using bullets for my roof line and Windows. I figure strips would be good for around my garden bed edging, hedges, and arches once they are added. Ideally I would like to keep the Christmas light bulb look as best as possible and from what I've seen so far the bullets are the closest thing to it (although I'm still open to suggestions if you know of a better option to keep the classic C6 or C9 bulb look.

Sent from my iPhone using Tapatalk


Reply
Posts: 1159
(@deonb)
Noble Member
Joined: 13 years ago
mharnish wrote:The voltage does not effect how many pixels are controlled at one time. You can get 5V or 12V pixel strips or strings and have full control over every pixel.

Could you link to a 12V pixel strip with individual control over every light?


Reply
Page 1 / 5
Share: