programming problem
 
Notifications
Clear all

programming problem

2 Posts
2 Users
0 Reactions
414 Views
Posts: 3
Topic starter
(@prashant)
Active Member
Joined: 14 years ago
[#57957]

Using PICkit 3 and MPLAB 8.30, I am trying to program several new PIC16F688's. I've done this before, but it's been a while.

I've created a new project, selected the device (PIC16F688).

When I select the PICkit3 as the programmer and power the circuit, I get a device mismatch that says "Target Device ID (000000) does not match expected Device ID (00001180)".

If I just continue on, the software acts like everything programmed fine with no errors,

If I replace the PIC's and take good PIC's, it behaves properly.

So, any idea as to where I'm going wrong? I presume the device mismatch error is the main clue. In fact, if I don't even have a PIC connected to the programmer I get the same error.

pleas Help me


1 Reply
Posts: 9
(@nwcworld)
Active Member
Joined: 17 years ago

if it's like the one i have make sure the jumpers are set right on the PIC programer


Reply
Share: