Activity Stream

Nice!

Anyone know if there’s any SPECIALTY equipment needed for my Pc to connect to the Renard espixel WiFi controller ? Items are starting to come in...

Don’t run it as a background effect, just run it as a looping effect.

The easiest thing to try first would be to swap switch ports out. Also, have you tried running test mode on the controller?

Nice work, I've been debating on doing something with my strips because staking them to the ground is a pain. I have the same boscoyo kit.

Looks good

I don't really know, that was the suggestion for a Tune To sign by someone from xlights. But you can do what I have done, which is to add it to each...

Can you explain why that should be 14? I thought it was correct at 7.

Background only run when no other sequences are running? I would prefer to run it during a sequence. Someone pulls up at the beginning of a 3 or 4...

your concerns are valid. some pixels wont have compatible timing to be inserted into the middle of a different type. the timing on the controller...

I’ve replaced several over the years on my tree with no issues. No real noticeable color difference to the people watching the show. I’ve even...

I've got around 40 and they literally just go into the attic stacked on top of each other. They are several years old and I have had low failure...

Part 3 was putting it all together. I did a quick test to get the strip height correct. I'm using 50 pixels per strip, at 2" spacing. That's 1600...

Part two deals with the base of the tree. There are lots of ideas out there. PVC, bending pipe, staking it to the ground, trampoline hoops, etc. ...

In xlights tree settings you are still set to # of stings 7, that would be 14. In Falcon change zig count to zero, as my instructions are zig zag...

Just create an effects sequence, eseq, in xlights for the Tune To sign to run the on FPP as s background sequence. Sent from my ASUS_A009 using...

I downloaded an app called FilMic Pro for my Samsung Galaxy 7. It allows to adjust the camera settings. Took a little experimenting, but at 20%...

The Pi does not have a real time clock, you would have to add on one for that to work, it does support NTP but there again, it has to have internet...

I like this !! All of it was done with the WeMos correct ? If so, is there a replacement for this board ? I can't seem to find any except for on...

I stack in a cardboard box using short PVC pieces over pixels as spacers......then rubber band them together. 1/2 X 1” front to front, and 3/4 X 2”...

The buss bars I've seen are for mounting in a breaker panel - and they are for solid wire only (from what I've seen). The "terminal studs" I've found...

The fix is in the latest development build if you want to verify it works for you.

The first pixel must not have been receiving data if the entire string stayed white .

I had this on one particular sequence and 1 run of pixels a couple of years ago and I changed the timing in the 682 to a longer interval for that run...

I replaced the string of pixels prior to tonight's show and the show ran with no hangs tonight..... I'll watch it a couple more nights before...

Thanks for the response... Ahhh....yeah 33 ohm.......I saw the 330 in the Ebay listing...."CSC08A03-330G DALE"....and my 'sometimers' picked up on...