My apologies for high jacking this old thread. I have two strings of the G-90 and would like to use a ESPixelStick to control them via wifi. So, do I ...
This may peak interest to all, using ESP-32 with level shifter to control 8 digital outputs to control 50 rgb nodes per output. The build cost $14.0...
Your biggest problem is the budget at this time. However, Holiday Coro (David) has ready to run controllers. I would go minimal four output controll...
As noted Holiday Light Express, I just checked, appears to have stock:
ags0000 wrote:@yohan shipping to 20120 for 5 strands of 50 pixels (21 lbs.) is $39 Sent pm Sent from my SM-G950U using Tapatalk
5 pixel strands to 20120
Please update on whats available.
how many you have left and pricing to 20120.
duramadmax wrote:xGROMx: The ready to run controller with pigtails, power supply, case and F16 is $380. Bare card is $200 Dinochristmas: Are you look...
I have one controller from Advatek Lighting; PixLite 16, . Do you have enclosure and power supply to run your lights. I can send you more informati...
aaron1 wrote:Thanks. I can use either 5v or 12v. I just wanted to be sure before I tried 12v and fried the board. 🙂 What pins did you use to conn...
aaron1 wrote:Thanks for the guidance. Just to be sure I understand... I can actually flash the ESPixelStick firmware to this hardware and it will wo...
I have purchased one of these A+ NodeMcu Lua ESP8266 ESP-12E CH340G WIFI Internet Development Board Module from ebay. . Then flashed firmware for ES...
