wilmar
wilmar
@wilmar
Noble Member
Joined: Nov 9, 2018
Topics: 102 / Replies: 2013
Topic
Forum
Replies: 25
Views: 13344
Reply
RE: The Simpler Things

algerdes wrote:Yesterday a friend, who owns a business with a larger building standing out on its own (nothing within 200 yards), asked if I could lig...

5 years ago
Forum
Reply
RE: Pixel Pops Controllers - Over 2,000 shipped - Just Keep Chugging Along

Works fit perfectly if anyone else needs Sent from my iPhone using Tapatalk

5 years ago
Reply
RE: Pixel Pops Controllers - Over 2,000 shipped - Just Keep Chugging Along

packetbob wrote:If you only need a handful (and don't wanna buy a bunch) PM your address and I'll send you some... I have a couple hundred (more than ...

5 years ago
Reply
RE: Pixel Pops Controllers - Over 2,000 shipped - Just Keep Chugging Along

packetbob wrote:That looks like it will work.... Thanks Sent from my iPhone using Tapatalk

5 years ago
Reply
RE: Pixel Pops Controllers - Over 2,000 shipped - Just Keep Chugging Along

Tactile switches seem to be out everywhere but found these can anyone confirm if these will work? Sent from my iPhone using Tapatalk

5 years ago
Reply
RE: Rbl ?

rsegreto wrote:Hey wilmar are you still selling these? I tried to PM you but your mailbox was full. If so let me know here or feel free to PM me. T...

5 years ago
Reply
RE: Rbl ?

rsegreto wrote:Hey wilmar are you still selling these? I tried to PM you but your mailbox was full. If so let me know here or feel free to PM me. T...

5 years ago
Reply
RE: Lowrider2 build

kockie wrote:Yes, i built an mpcnc 2 years ago. Did a lot of woodwork and foamwork with it. It turned out quite big and a little too floppy, so I want...

6 years ago
Topic
6 years ago
Replies: 4
Views: 3578
Reply
RE: MicroSwiss direct drive

Popo-B-Trippin wrote:Is the 75mms with a 4 or 8mm nozzle? .8mm Sent from my iPhone using Tapatalk

6 years ago
Reply
RE: MicroSwiss direct drive

Jeff Millard wrote:Was the Hot End necessary, or could you have left the upgraded Creality Replacement Hot End on it? I just replaced the original wit...

6 years ago
Reply
RE: MicroSwiss direct drive

woganaga wrote:Good to know! I got the micro Swiss hot end kit a few weeks ago but haven’t installed it yet after I read elsewhere about retraction ...

6 years ago
Topic
Reply
RE: Xlc-9

virgil1 wrote:I got around to printing one of these, and I didn't bother to look at the dims. These are much bigger than 'normal' C9s, but the openin...

6 years ago
Page 3 / 141