underdog
underdog
@underdog
Estimable Member
Joined: May 21, 2010
Topics: 7 / Replies: 178
Reply
RE: FM02 Modified CD Drive, Computer Mounted

DaveJZ wrote:Hate to awake a dead horse.... but how does it sound on the radio? Any noise from the computer???? Also which antenna are you using a...

15 years ago
Forum
Reply
RE: High winds

Re: Hight winds I know how you must feel, the night after I finished my 20 Foot megatree we had some 45-50mph sustained winds and gusts up to 60+mph....

15 years ago
Forum
Reply
RE: 100 Count Strings...Maybe

So much for telling people nice round numbers like "I have 8000 lights"...."Actually no, I have 7987 lights!" Oh well!

15 years ago
Reply
RE: 100 Count Strings...Maybe

Chris, I've found that out this year exactly like you; When I was building my window frames! I was going for 4 channels/4 strings of lights on each Re...

15 years ago
Reply
RE: Banning Lights in the neighborhood...

Bah humbug! I not too surprised, in a neighborhood local here they have requirements for luminary type, color, and spacing. Scrooges of America *shaki...

15 years ago
Forum
Reply
RE: RenSS24 Dim Issue - Other Channels Flicker

LabRat wrote:Dunnsr, When you say "half your show lights up", would it stay lit? I was experiencing very bad flicker/cross talk when dimming a single ...

15 years ago
Forum
Reply
RE: antanne placment

Range, Yes. Sound quality, perhaps if better signal is being received then it will sound better, but remember the old adage "junk in=junk out". The #1...

15 years ago
Forum
Reply
RE: Christmas Music

ErnieHorning wrote:I’ve been listening to Christmas music for a few months now. It’s a whole lot easier now than when I was picking out the songs for...

15 years ago
Forum
Reply
RE: Looking for sound clip national lamponn's christmas

Disneynut the song is called "Lindsey Buckingham - Holiday Road", from the Lampoon's movies

15 years ago
Forum
Reply
RE: Channel # 3

Good deal, glad to hear. If you're worried about this happening again, I'm pretty sure this is an isolated case. These SS boards are high quality and ...

15 years ago
Forum
Reply
RE: Channel # 3

ctmal wrote:Ok, that narrows down where the issue could be. Can you check for continuity between Pin 12 of the pic socket and pin 2 of the opto? I w...

15 years ago
Forum
Reply
RE: Channel # 3

Have you mapped out and followed the traces? Sounds to me like a trace may be bad. If so, it's not a worry, place a jumper wire in where the path of a...

15 years ago
Forum
Reply
RE: To everyone that does there own sequencing

I agree, I'm feeling the rush now too, I have gradschool 3 nights a week and that eats up too much time! I'll be working every weekend and late nights...

15 years ago
Forum
Reply
RE: Soldering Heat vs Wattage

I use a Metcal STSS-001, It uses RF to heat the tip, and maintain temperature. I think I use a 750series for general purposes and then the 850 for gro...

15 years ago
Reply
RE: WLC Ventures

I agree, my mother always said "Son, poor planning on your part does NOT constitute an EMERGENCY on mine." I bought my boards and BOM last August or S...

15 years ago
Page 5 / 13