tweist
tweist
@tweist
Reputable Member
Joined: May 14, 2009
Topics: 23 / Replies: 371
Reply
RE: Traffic counts

This is our 5th year doing this. The first year it was slow, 20 to 30 cars per night. We are now estimating 150 to 200 per hour now. They start lin...

13 years ago
Forum
Reply
RE: Need help with newly assembled 64XC and one from last year

Just let us know what the problem is on the last board and we will give you suggestions. Do you have any input power? Is the power LED on? Put in yo...

13 years ago
Forum
Reply
RE: Need help with newly assembled 64XC and one from last year

I use a small screw driver to get under the PIC and then slowly start lifting one end. Once it is high enough, I use a pair of long noise pliers to l...

13 years ago
Forum
Reply
RE: Need help with newly assembled 64XC and one from last year

This may be a dumb question, but do you have a Ren plugin setup with the correct channels for the new boards? and is it enabled?

13 years ago
Forum
Reply
Reply
RE: Need help with newly assembled 64XC and one from last year

You may have used the wrong firmware, or you may have used the correct one and just have not set up the parameters correctly. You may also be able t...

13 years ago
Forum
Reply
RE: Need help with newly assembled 64XC and one from last year

Per the assembly instructions, Install the eight (8) 680 ohm resistor networks R10-R13 and R20-R23. The resistor network should have a dot on it to in...

13 years ago
Forum
Reply
RE: Need help with newly assembled 64XC and one from last year

Javo wrote:1. I just finished assembling my third 64XC. The first two work great, the problem is with my third board. When I power it up I have ...

13 years ago
Forum
Reply
RE: ElfPreview Output PlugIn (new)

MacabreRob wrote:How are you configuring it to do this? 2 output plugins assigned, with a subset of channels in each? I will look into it. I am actua...

13 years ago
Reply
RE: ElfPreview Output PlugIn (new)

With the adjustable preview, I can put more than one on the screen at a time. Is that also possible with ELF?

13 years ago
Reply
RE: I'm a total newbie

Jake One thing to remember, start small and build up to it. You can always add to your show, but if you start out to big, it will over whelm you and ...

13 years ago
Reply
RE: Oscillators for Renard boards

Thanks Phil This is great information. I think I will investigate the new PIC and see how well it will work with my setup. It could help me shrink ...

13 years ago
Reply
RE: Oscillators for Renard boards

kingofkya wrote: I think that will work double check pin out in data sheet. It is a bit smaller but i think it will be ok. I found that same one in...

13 years ago
Topic
Replies: 15
Views: 4764
Reply
RE: Happy Birthday, Wayne J

Happy Birthday Wayne.

13 years ago
Forum
Page 3 / 27