From what I know, the 2-wire GECE lights are not hackable/controllable. Only the 3-wire and 5-wire GECE lights are hackable.
knightrohulk wrote:I ended up using an ESPixelStick with Shelby code. It just automagically worked. However, I have the G90 pathway lights not the one...
The five-wire GECE lights that were released last year (and the year before that?) work fine with my GECE controllers. I am using Arduino and ESPixel...
I am also using ESPixelSticks with the newer GECE strings. What I did was built an ESPixelStick "tube". I put it in-inline between the GECE power su...
TomL8345 wrote:Ken, I have not built them yet. On my to-do list for this year. Ken, The enclosures that I bought from eBay work fine. One of th...
gecolor wrote:Would you mind providing some details (pictures/wiring diagram) of how you wired up the new GE strings from Lowes? I was following the t...
OK, thanks Rob! Tom
Hello, I bought the following 20W enclosures that RobG recommended: They fit RobG's 20W pixel boards just fine! I noticed the enclosures come wit...
Thanks Rob and SetMonkey! I ordered the 20W enclosures. Now I have lots of soldering to do. 🙂
Thanks for the instructions! Can you send me the link to the 20W enclosure that you used? I assume that the 10W version is too small or would that f...
Hi Rob, With the third link that you provided: "update - very good deal", will the 20W ws2811 circuit board fit into the 10W enclosure or should I bu...
Hi there, Good to hear that you have your boards working! Can you tell me where you found the instructions? Thanks, Tom,
I doubt that the 63 limit has been taken away on the 2016-version G28 bulbs. I think up to seven sets the of 36-bulb strings can chained together (...
madsci1016 wrote:Huzzah! Confirmed and my gut was right about the changes. I'd love to see what the inside of the new controller box looks like. Did...
I confirmed that the 2016 five-wire GECE bulbs use the same protocol as the "original" GECE. I have the 36-count G28 bulbs that I bought at Lowe's to...
