tim1073
@tim1073
Active Member
Joined: Dec 10, 2008
Topics: 0 / Replies: 7
Reply
RE: WS2801 and Arduino Uno

cliff smith wrote:I'm taking the power for the strings from external power supplies not direct of the arduino, and then just swapping the data line ov...

12 years ago
Reply
RE: Arduino Renard Library, pixel bridge in 10 lines of code!

The biggest problem with serial and pixels is the serial transmission time. At a 57600 serial rate, you are going to have to set the vixen refresh ti...

12 years ago
Forum
Reply
RE: WS2801 and Arduino Uno

I think you have two problems with your code. First, as LightUp suggested, you don't have any way of synchronizing with the start of the data stream. ...

12 years ago
Reply
RE: Pixel controller firmware

Any way you could attach the .asm file? Now that the holidays are over, one of the projects I've been planning was this exact controller (well almost...

12 years ago
Reply
RE: max number of pixels per arduino pin

You will definitely need to inject power into each RGB strip since the Arduino power supply only has enough power to run about 10 pixels on its own. ...

12 years ago
Forum
Reply
RE: Good source for an Arduino UNO R3 + Ethernet shield

jchuchla wrote:I haven't found that to be the case. It doesn't seem to be temperature related. When I say cold start I'm referring to powering up fro...

12 years ago
Forum
Reply
RE: Arduino as pixel controller

I wrote something very similar using an Arduino Mega and the W5100 ethernet shield and found that it could only process every other and sometimes ever...

12 years ago
Forum