ThomasLED wrote:Let me know what you measure at the three locations. - Thomas J8-2: 12.25V C19: 300-350 mV C26: 300-350 mV
No, I checked the jumpers and they are fine. It was running fine last week and I have done absolutely nothing to it. Also, it's running off the 12V pl...
Uh-oh...powered on my PixelRadio today and got this...I haven't done a thing with this since last week when I powered it on and went through the vario...
Connected 1st time!! *does happy dance*
3 different USB cables, 2 different ports, and no luck. There is no "chime" to indicate that there is a connection happening. When the ESP32 module is...
Well, I can't seem to get the VS Code program to see which COM port my ESP device is using, and I've tried finding out which one, to no avail. I've go...
ThomasLED wrote: As mentioned in the Hardware Information page, socket mounting is recommended. The added height will provide space for the 3D printed...
Quick question: I never loaded the software onto the SD card and tested the ESP module by plugging in a USB cable to connect it, but soldered the modu...
A package arrived today, and it had all the other items: transistors, regulators, MUX chip, enclosure, antenna, power connector, audio connector, and ...
Keith R wrote:I can certainly appreciate this. Otherwise, I would not have attempted it. Thanks! I bought a second one because it was $99 at Micr...
TomL8345 wrote:I was able to use 1/4w resistors in the normal orientation, mine fit just fine. - I have gotten distracted from my build by the purchas...
rayhjr wrote:Success! I finished soldering the board Friday night (2 large Bags of goodies from AliExpress arrived Friday) and tried to upload to the...
I'll try to find those files, but honestly I've looked on the GitHub page and didn't see them. Edit: found the files, yay!
ukewarrior wrote:Your PM box is full. Deleted some messages. Please try again.
ukewarrior wrote:I've printed both sides. The stl's seem well done and easily printed with no supports. The picture below was printed on an ender 3 P...
