I'm testing with Release 3.6u4 Build #937 I hope to pickup the actual show computer this weekend an I'll get you the version # off it and test with it...
I figured it out!, It was a Vixen configuration issue. So I found it when I realized that even the preview wasn't showing the items and after much pla...
That sACNview is a very handy tool. Everything works as expected using sACNview 'transmission' feature, so I assume that confirms my suspicion of a Vi...
It's a Hand built ESP Board, pretty much just the bare minimum for the ESP, voltage regulator the appropriate pull up/down resistors and GPIO2 connect...
So I have some down time due to the current global 'situation' so I thought I would revisit my ESPRenard project/issue. I have re-flashed the ESP with...
WiFi Renard Controller is setup as a sACN device Unicast to 192.168.1.3 in Vixen, The ESP is set to DHCP but I have 192.168.1.3 reserved for it in the...
Unfortunately, The sequence was created from scratch after my last backup, and then I started making changes right after I saved the first sequence. O...
OK so I copied my sequences and music to a new copy of vixen, verified all com settings, then I created 2 new sequences, one that starts with all chan...
OK so now nothing works, I can occasionally get the lights to turn on from the "Test Channels" for any sequence. When a scheduled show is supposed to ...
OK, so I followed Gebbinn's instructions and used that code and still nothing. My vixen is on a flash drive and i have been running it with my old net...
well my show ran once at 5:30 as scheduled, background music started but... no lights came on and vixen stopped responding (but background music conti...
I don't see how that code would turn the lights on at 5:30 and off after 11 but My C# is a little rusty. void Start() { Off (All); DateTime now =...
