rukiddin
@rukiddin
Eminent Member
Joined: Oct 12, 2012
Topics: 5 / Replies: 25
Topic
Forum
Replies: 12
Views: 10893
Reply
RE: First time SS24 builder.. Need help

Wayne J wrote:The best way to test the board is..... follow the wiki, it's why we wrote it. :thup: I actually read the wiki, but was still a little...

14 years ago
Forum
Reply
RE: First time SS24 builder.. Need help

Guys.. Just reporting back.. EVERYTHING IS WORKING! Made the cable, finished hooking up all 24 Power leads, plugged in 24 XMAS light strings, and ma...

14 years ago
Forum
Reply
RE: First time SS24 builder.. Need help

CaptKirk wrote:The diagnostic firmware is really designed to only be used in the first pic. It verifies the board is mostly functional. The next tes...

14 years ago
Forum
Reply
RE: First time SS24 builder.. Need help

Ok, the Oscillator (U3), was installed in the correct orientation, and the solder joints looked good, but I re-did them anyhow, and now it appears to ...

14 years ago
Forum
Reply
RE: First time SS24 builder.. Need help

RavingLunatic wrote:OK, you can stop right there. If that didn't result in some activitiy with the on-board LEDs (or output channels) then you have a ...

14 years ago
Forum
Reply
RE: First time SS24 builder.. Need help

gassy wrote:Did you get the PICs recently from Mouser? I had the same problem as you, flashed the PICs, verified, put them in the board - nothing. I h...

14 years ago
Forum
Reply
RE: First time SS24 builder.. Need help

Working on the cable now.. As for the lights, I have normal lights (just 60 watt bulb) plugged in at the moment. I'll check the orientation of the c...

14 years ago
Forum
Reply
RE: First time SS24 builder.. Need help

Ok, Did some re-flashing.. got some interesting results. Even though last night I verified EVERYTHING, I clicked "Blank Check" this morning, and all...

14 years ago
Forum
Reply
RE: First time SS24 builder.. Need help

This was my first Soldering job, so am I confident? eh? although I did practice on a "practice" board I bought at Fry's first and I watched a lot of Y...

14 years ago
Forum
Reply
RE: First time SS24 builder.. Need help

I'll reflash the firmware for sure.. If I power the board up not attached to a PC and have the PIC programmed for normal operation, what should hap...

14 years ago
Forum
Topic
Forum
Replies: 24
Views: 6073
Reply
RE: BOM for Solder Starter Kit

amps wrote:Really, at a minimum you should have a solder sucker, a tip cleaner and a 3rd hand (for holding stuff you're soldering). And I'm assuming...

14 years ago
Reply
RE: BOM for Solder Starter Kit

CaptKirk wrote:Absolutely VITAL to have at least one of these: Pricey but worth it.... 😛 I can see the value!.. I just picked one up at Dol...

14 years ago
Topic
Replies: 26
Views: 5400
Page 2 / 2