rogelio
@rogelio
Estimable Member
Joined: Dec 28, 2011
Topics: 11 / Replies: 101
Reply
RE: Can you save the Blob?

the answer to your question is yes. The end blobs contain 1 set of diodes each and The middle blob contains 2 sets of diodes. one set for each half. ...

13 years ago
Forum
Reply
RE: Fair Warning, Home Depot "Ecosmart LED" Strands NON dimable...

What makes them "non dimmable"? If they are half wave, that does not mean they do not dim.

13 years ago
Forum
Reply
RE: $3 Banner from Shindigz

scootchu, I like your sense of humor. 🙂 Good to know someone else thinks like me.

13 years ago
Forum
Reply
RE: Cutting LED Light Strands

If your VOM will not do milliamps, then a separate milliamp meter will be needed. Most Christmas leds, in fact most leds, are rated at 20 milliamp ma...

13 years ago
Forum
Reply
RE: Cutting LED Light Strands

That is very similar to what I use. 1/2Watt. Just note, shortening a string down to just a few leds like Danny did, will push the wattage through th...

13 years ago
Forum
Reply
RE: Cutting LED Light Strands

Danny did you get my reply? I do not know if it was sent. Roy

13 years ago
Forum
Reply
RE: Swapping and shortening led strands

If you are trying to shorten a string to a custom length, this is how I do it. My replies are #9 and #13.

13 years ago
Forum
Reply
RE: Ray Wu's Pixel strips 5M at Full Power flicker on E682

has anyone actually measured the wire gauge? I received some sets of pixels from Ray last week. They have "20 ga." printed on the insulation BUT the...

14 years ago
Forum
Reply
RE: Cutting LED Light Strands

ma is milliamps. 1/1000 of an amp. A current reading. Most christmas style leds require somewhere around 10 to 20 ma. You should have set your met...

14 years ago
Forum
Reply
RE: 3w RGB tricolor(on star heatsink) - make a color bar

thats asking a lot. Do the stars have constant current drivers already? control each star separately or as a bar? simple on/off control or dimming?

14 years ago
Forum
DMX
Reply
RE: Silver Linings Playbook

I just thought it was a conversation in the lounge about something other than blinking lights 😐 877 post isnt usually a spammer One of the things...

14 years ago
Forum
Reply
RE: Silver Linings Playbook

really a good movie. Do you make crabby snacks and homemades? 🙂

14 years ago
Forum
Reply
RE: Stand alone controller

I know the Lynx Conductor will do it.

14 years ago
Forum
Reply
RE: Swapping led bulbs in clear strings

Yes that is correct, you may have to change resister. Forward voltage of a white led is around 3.3 volts while a green led is around 2.2 volts. So y...

14 years ago
Forum
Reply
RE: Swapping led bulbs in clear strings

Yes. I do it. I would check current of the original string, modify it, then check current of modified string and adjust resister to maintain the ori...

14 years ago
Forum
Page 3 / 8