PinakBERT
@pinakbert
Reputable Member
Joined: Jan 2, 2011
Topics: 33 / Replies: 225
Reply
RE: PX1 Power plug was with reversed 12V Polarity. What to replace?

thanks Phil, I haven't been watching what has been happening with the ESP boards. Nor the funds to change over what I currently use. My controllers co...

6 years ago
Forum
Reply
RE: PX1 Power plug was with reversed 12V Polarity. What to replace?

thanks Mike. I'll see what I can do to mod my PX1 boards

6 years ago
Forum
Reply
RE: PX1 Power plug was with reversed 12V Polarity. What to replace?

Well i finally came back to fixing this board. I had a spare i was using. Anyway it was U3 that I replaced. When I powered it with 12v the LED came o...

6 years ago
Forum
Reply
RE: My first year

I almost thought I was Rick Rolled...

8 years ago
Forum
Reply
RE: Water proofingn cardboard?

What about 1/4" or 1/2" Sintra to apply the sticker to? When I worked at a tradeshow shop that did most of the major auto shows displays, they used m...

9 years ago
Forum
Reply
RE: Where are you??

Still on Renards and incans mostly... 2-SS24 (2 more still need to assemble), 1-64XC, REN48LSD to Run REN4Floods and DIYC Floods, and 2 PX1 boards (2-...

9 years ago
Forum
Reply
RE: AC lights tripping GFCI when it rains.

yosemite wrote:I take a small dab of silicone sealant and put it at the base of the male connector then plug them together. Then keep them off the gr...

9 years ago
Reply
RE: Got a 3d printer for Christmas

its usually a bed level problem or check to make sure cura has the correct diameter set for your filament. Default is 3mm... if your filament is 1.75 ...

9 years ago
Reply
RE: PX1 Power plug was with reversed 12V Polarity. What to replace?

I doubt I have enough room to get something down there to cut. I'll try though. Maybe if I'm fast enough with a de-solder sucker. Can I still run my 1...

9 years ago
Forum
Reply
RE: PX1 Power plug was with reversed 12V Polarity. What to replace?

I just measure the PIC at pins 1 and 14.... 0V =(

9 years ago
Forum
Reply
RE: PX1 Power plug was with reversed 12V Polarity. What to replace?

MartinMueller2003 wrote:The voltage going to the CPU must be 5v. Please check the CPU voltage. Where do I test that? looking at some schematics and ...

9 years ago
Forum
Reply
RE: PX1 Power plug was with reversed 12V Polarity. What to replace?

Barnabybear wrote:Hi, I would suspect the voltage regulator is dead: If you measure the voltage with a probe on ether side of C2 what reading do yo...

9 years ago
Forum
Reply
RE: PX1 Power plug was with reversed 12V Polarity. What to replace?

Barnabybear wrote:Hi, I would suspect the voltage regulator is dead: If you measure the voltage with a probe on ether side of C2 what reading do yo...

9 years ago
Forum
Reply
RE: PX1 Power plug was with reversed 12V Polarity. What to replace?

I swapped out the fuse from another working px1 and LEDs still don't turn on. Any suggestions??

9 years ago
Forum
Topic
Page 1 / 18