Activity
 
Notifications
Clear all
Penfold
Penfold
@penfold
Noble Member
Joined: Dec 5, 2007
Topics: 182 / Replies: 1053
Reply
RE: Do I use both the BBB and the Raspberry Pi?

rayhjr wrote:Yes. I use my RPi 3B+ as a Player and the BBB16 as a Remote. Different FPP downloads for each. Not player and Remote but RPi and BBB. T...

4 years ago
Topic
Reply
RE: Anyone Repair Falcon Controllers

It sounds like there may be a fried power trace or a voltage regulator may have blown. Look at the bottom of the board to make sure there isn't a bro...

4 years ago
Reply
RE: Edm-tx-lcd replacement with rds

I have the EDM-LCD-RDS. I had to wrap the internal electronics in tinfoil as it was causing bad interference. I had to keep the transmitter away fro...

4 years ago
Forum
Reply
RE: CG1500. What else is out there?

1pet2_9 wrote:How about an enclosure that only holds one power supply? (~350W-400W) The ammo crates hold a Kulp32 and a power supply. As stated ...

4 years ago
Reply
RE: CG1500. What else is out there?

rstehle wrote:You are welcome. In case you get too much 'attention' from your local LEO's, IIRC, the word AMMO is on a decal that you can peel off if ...

4 years ago
Reply
RE: CG1500. What else is out there?

mrGrumpy wrote:These guys have GC1500, and they are a great supplier I ordered an Ammo box for on the front porch. I may look into getting these f...

4 years ago
Reply
RE: CG1500. What else is out there?

Aurbo99 wrote:I switched to IPEX 884 (8x8x4) a few years ago. room for 2 psu's and an e682 with wires and bulkhead style rj45 connector, power switch...

4 years ago
Reply
RE: CG1500. What else is out there?

rstehle wrote:Many of us have started using a box called the "Ammo Crate" Readily available on Amazon...... :naughty: Ohhhhhhh Military green and i...

4 years ago
Topic
Replies: 21
Views: 6879
Topic
Forum
Replies: 2
Views: 8709
Reply
RE: BBB16 Assembly questions

toy keeper wrote:1 & 5, The DC to DC converter goes in the 7805 spot. Is there a specific orientation that the DC to DC converter goes in?

4 years ago
Topic
Replies: 8
Views: 2550
Reply
RE: Trying to expand my pixels count

I have just put in my first order to JLCPCB for the BBB16 (In blue as recomended) through hole (I may go SMD in the future). I have looked at the par...

4 years ago
Reply
RE: Extected Pixel Failures in new strings

I have only used 12v pixels and only found maybe 2 out of 200 pixels during burn in. These were from Ray Wu back in 2012. When I ran them in my show...

4 years ago
Page 2 / 83
Share: