packetbob
@packetbob
Estimable Member
Joined: Oct 30, 2009
Topics: 7 / Replies: 112
Reply
RE: Pixel Pops Controllers - Over 2,000 shipped - Just Keep Chugging Along

If you only need a handful (and don't wanna buy a bunch) PM your address and I'll send you some... I have a couple hundred (more than I will ever use)...

5 years ago
Reply
RE: Single channel AC dimmer

You can always try the Robotdyn triac module and load it up with as many lamps as you plan and see what happens.... I have a assembled SSR4 that you c...

6 years ago
Forum
Reply
RE: Single channel AC dimmer

No experience directly but I would heavily de-rate the capacity of the Triac.... If you are interested I have some 4 channel DMX AC dimmer PCBs and p...

6 years ago
Forum
Topic
Replies: 1
Views: 6
Reply
RE: Espixel by Bill Porter

filibar's experience is interesting... I have built a good 40 of the ESPixelPOPs boards (running both ESPixelStick and WLED firmware) and connected t...

6 years ago
Reply
RE: Ws 2811 Ws 2812 or ApA 106 in a straw hat

Wil be around.. Promised myself I'd clean out the garage... Mind you I have made the same promise every weekend this year....

6 years ago
Reply
RE: Ws 2811 Ws 2812 or ApA 106 in a straw hat

I have a pile of them if you don't wanna have to wait till your shipment arrives.....

6 years ago
Reply
RE: Ws 2811 Ws 2812 or ApA 106 in a straw hat

I have some of the AP106 variant and they seem to work fine (also have some of the larger 8mm versions)... A potential caveat is that they *should* ha...

6 years ago
Reply
RE: Snow Machine Outside

I have an Antari snow machine that I use sometimes... I made a cover out of a large upside down Rubbermaid tote. I cut out a section in the front for ...

6 years ago
Reply
RE: Address

Very nice.... Do you pics of how it looks during the day and how you mount them? I installed backlit ones from HomeDepot a few years back and a few...

6 years ago
Reply
RE: E1.31 Servo Controller

Thanks for posting the link to your skull files on Thingiverse... Just got a Ender 3 V2 and have just started doing some prints... Just did the upper ...

6 years ago
Forum
Reply
RE: Tired of my flakey Prusa I3

First print is a xyz calibration cube.... Used the stock settings for everything....

6 years ago
Reply
RE: Tired of my flakey Prusa I3

So can certainly recommend the Ender 3 V2... Went together pretty quickly (though I followed a YouTube guide rather than try to follow the manual) Did...

6 years ago
Reply
RE: Are there any diy e1.31 bridges?

Barnabybear Thanks for posting the list of your code!! Barnabybear wrote:Hi, not pic it uses an Arduino Nano, ENC28J60 Ethernet shield and a RS485 m...

6 years ago
Page 5 / 8