Snow Machine Outsid...
 
Notifications
Clear all

Snow Machine Outside

6 Posts
4 Users
0 Reactions
3,941 Views
Posts: 149
Topic starter
(@randomaker)
Estimable Member
Joined: 7 years ago
[#53931]

How does everyone keep their snow machine from getting wet outside? Put it in some type of box with a hole in the side? Put it under an overhang? Let it out in the rain? Also what is your setup for refilling?
Thanks!


5 Replies
Posts: 344
 TSL
(@tsl)
Reputable Member
Joined: 10 years ago

Sorry can’t help you. Mother Nature is my snow machine. Sometimes she’s works good. Sometimes not so good and other times too good.[emoji3]

Sent from my iPhone using Tapatalk


Reply
Posts: 237
(@spankyty)
Reputable Member
Joined: 10 years ago
Randomaker wrote:How does everyone keep their snow machine from getting wet outside? Put it in some type of box with a hole in the side? Put it under an overhang? Let it out in the rain? Also what is your setup for refilling?
Thanks!

I would like to learn more about snow machines.


Reply
Posts: 119
(@packetbob)
Estimable Member
Joined: 17 years ago

I have an Antari snow machine that I use sometimes...
I made a cover out of a large upside down Rubbermaid tote. I cut out a section in the front for the blower output. It keeps the rain out...
It does look like snow when falling in front of you so pretty realistic..
However they are noisy, go through lots of "juice" (I make my own) and cover everything the flakes (in reality small groups of bubbles) land on gets soapy and slippery...
Refilling can be a pain if it is mounted high up (say on your roof) so I have thought of setting up a large remote tank with a pump but have yet to get around to it...


Reply
Posts: 149
Topic starter
(@randomaker)
Estimable Member
Joined: 7 years ago

Ive decided to make a plywood box to put snow machine/controller in. I will put some hanger bolts in the studs above soffit so I can just use a few nuts to hang it. I am building my own Arduino DMX controller. For refilling, I will have a 5 gallon bucket with submersible pump, hose goes to a small container in the box. Hose from snow machine will be taken out of its internal container and go into that one. There will be an NC float switch in the container to tell the pump when to turn on, and an NO float in the bucket as a low solution shut off. They will be connected in series and control a relay for the pump. There is also an NO float in the container connected to the controller for a low shutoff for the snow machine itself. Havent built any of this yet, but maybe it will help someone. I am planning on making a youtube video, I will link it if I remember.


Reply
Page 1 / 2
Share: