Ahhh... another Hackaday subscriber! (y) I've discovered so much cool info and stuff on that site. Hadn't seen this particular link in there yet tho...
Thanks, just had to be sure(y)
Just came across this post... Is there any possibility that Vixen 3 will be ported to linux in the future? I would sure like to use some flavor of lin...
I think it was color order (RGB, GRB, etc). Can't remember off hand what I had to change it to for my pixels though although I could look when I get t...
Tried again yesterday afternoon with sand heated to about 400 degrees (found a better digital thermometer) and it worked a little better but not quite...
Update - My first attempt at re-shaping the PEX tubing into a candy cane didn't quite work. I used the hot sand technique. I used my trusty old Colema...
I imagine it would probably be a good idea to experiment on a scrap piece of coro first though. It might be that too many holes punched with these ty...
Oops.. just realized I put my last post into the wrong thread. That's what happens when you have too many tabs open in the browser! 🤪
The leather punch pliers are available in many places. I've seen them at Home Depot, Harbor Freight, hobby shops in general, and even yard/garage sale...
The leather punch pliers are available in many places. I've seen them at Home Depot, Harbor Freight, hobby shops in general, and even yard/garage sale...
I wonder if a leather punch tool would do it? It's a pliers tool with a flat on one side and a rotating tool on the other (rotates to select different...
I totally identify with the remembering of stuff... I'm the same age as you. 😄 I'll poke around on youtube as see if I can find it. PEX is a bit soft...
I'm finally dropping back in after an entire year.... I did follow the thread last year as it was progressing along but when January came I just got ...
