I did this exact thing in 2014. You can see the details of my build here: Not a cheap build, but it has worked flawlessly for 3 seasons now. Ther...
I have my entire roofline done in Pixabulbs. I did this a few years ago, chose Pixabulbs because of various reported issues back then with the Techni...
Yeah, it may have to wait until next year. The wife was happy with this layout, that was the most important test. I still have quite a bit more to d...
Wolfie wrote:Here is one using almost the exact same figures as yours: I wish I had seen this picture before I got all the cords lengthened and ev...
Here is what I ended up with. It is 10' wide and 5' deep.
I forgot to mention that. This will be sitting about 40' back from the viewing location, with my 6' Bethlehem star about 30' above it.
tjetzer wrote:Yes you can. You can also get a POE power injector that plugs between your non-POE switch and your POE cameras to take advantage of the...
I don't have the wiring details for the full prop worked out yet. It will have 20 pixels on each spike, so my thought is to run 2 branches off each c...
I am building a similar tree topper for this year. I have the frame built, just waiting for my pixel strips to arrive. This drawing is kind of crude...
Here is my roofline layout. Each segment of lights (except the windows) is a single line model of RGB nodes. Then I grouped all of them into a roofl...
I used Microsoft Visio, but I have it on my work laptop so it didn't cost me anything...
Ok, I can make that work, but a couple more questions. Is 5A for each strip too big given the draw that I measured? I'm still nervous about my measu...
mrGrumpy wrote:Thought: can you move power supplies. I could do that, I realize this would be the optimal setup for power distribution. It would...
