Re: Ren 24 LV Board Order Could this board control MR16 led floods? If so how many would I need for 20 MR16s?
Here's an update with the two ren24s. I put them to the side and went on the quest to complete the rest of the boards. While I was assembling the ne...
The serial comunication is good - I have two boards that tested ok. I even swapped around the pics from the good boards to the ones that aren't worki...
I am testing the boards seperately. The power led lites up on both boards. When I put the diagnostic chip in, the red leds blink. When I put pics i...
It is the one that is used in this video:
Reddy_Kilowatt wrote:Do you have jumpers jp1 and jp2 set for 120V and a jumper set for transformer power on? The leftmost PIC controls outputs 1-8 fo...
I am testing the ssrs using the controller board. The cat5 is plugged into the same rj45 and I am testing the ssrs one at a time.
I use the same cat5 cable from the ren64 to test each ssr. It couldn't be the cable.
I have two working ren64 controllers! The problem was that the chips weren't flashed correctly. I used one of the chips from the first board and the...
P. Short wrote:There aren't any MOC3023 chips on the Renard64. Instead I would double-check the stuff that is common to all of the PICs, such as powe...
Payment sent. Thanks
