MrLights2000
@mrlights2000
Reputable Member
Joined: Jun 10, 2007
Topics: 76 / Replies: 148
Topic
Reply
RE: Xlights or vixen ?

rstehle wrote:I think asking that question on this forum will get answers leaning toward Vixen. If you ask the same question on DIYO, you will probab...

7 years ago
Topic
Replies: 22
Views: 23533
Reply
RE: Network question

hijacking this tread a little but is it actually nessasary to even have your show connected to your network if u don’t use a pi to run the show. Can I...

7 years ago
Reply
RE: Looking for p10 panels

mrGrumpy wrote:only 4 - DIYLEDEXPRESS.com has 4 and on sale I’ve messaged and email him looking for something I ordered from him in December and he ...

7 years ago
Topic
Replies: 4
Views: 3157
Reply
RE: trouble with sandevices e682

Wow thanks guys Moved ! seems to have powered up correctly now 3 yellow leds steady and the red steady and a flickering green ! Sent from my iPhone ...

7 years ago
Reply
RE: trouble with sandevices e682

iflights wrote:You are missing the voltage regulator. IC1. In fact it is installed, but in the wrong location. J26 ? Sent from my iPhone using ...

7 years ago
Reply
RE: trouble with sandevices e682

pmiller wrote:You should have contacted Jim at Sandevices. He would have sent them out right away. Keep that in mind. Sent from my SM-T710 using Tapa...

7 years ago
Reply
RE: trouble with sandevices e682

pmiller wrote:I hope your propeller chip doesn't fail. Unsoldering 40 pins is laborious unless you have a desoldering tool. There should have been a 4...

7 years ago
Reply
RE: trouble with sandevices e682

iflights wrote:Post a relatively high-resolution photo of the component side, and the solder side of your E682? I can compare against my spares.

7 years ago
Reply
RE: trouble with sandevices e682

pmiller wrote:Do you have power to both sides of the board? Check your fuses. If you're powering the board and pixels with 12 volts make sure you have...

7 years ago
Reply
RE: trouble with sandevices e682

pmiller wrote:Do you have power to both sides of the board? Check your fuses. If you're powering the board and pixels with 12 volts make sure you have...

7 years ago
Topic
Replies: 23
Views: 5423
Reply
RE: Sandevices questions about pixel counts

pmiller wrote:If those are the snowflakes I think they are each has 48 pixels. Running at 25% to 50% wouldn't require injection. I have those snowflak...

7 years ago
Page 2 / 15