mikeh65
mikeh65
@mikeh65
Prominent Member
Joined: Dec 7, 2007
Topics: 79 / Replies: 715
Reply
RE: How to space lights along an extension cord

I would suggest these: Gilbert plugs are also known as vampire plugs. Used by many display hobbyists all over. You can start at one end and put p...

3 years ago
Reply
RE: Works in Xlights but pixel shifted in Fpp

I don't know xLights but when you render do you also get an universe output file? This sounds like a universe setup issue. You don't have the FPP o...

3 years ago
Reply
RE: Network setup using old router

Since I run a closed network, it's only for my show. I set all my devices with static IP addresses. Each one gets set to its own address. Since I o...

3 years ago
Reply
RE: Pixels stuck

Try unplugging and plugging in the string. It may help. Are the pixels in the middle or at an end? If they are at the ends, check your patching. ...

3 years ago
Reply
RE: Help Request: Chaining LED Strips - 2nd Prop Not Lighting

If the lights end at the same spot on #2 window, no matter the order the windows are put in. I would think of two possible issues. 1. Mike could be...

3 years ago
Reply
RE: Help Request: Chaining LED Strips - 2nd Prop Not Lighting

If you swap the windows does the issue stay the same? How many pixels are on each window? Is the output from the controller a separate one for the...

3 years ago
Reply
RE: Separate power for Lights from blower

1pet2_9 wrote:I like your idea. I bet those China special 20w ws2811's would work. Just ziptie a clear plastic bag around it for a little more weath...

3 years ago
Forum
Reply
RE: Separate power for Lights from blower

I actually run a strip of pixels up the middle or my inflatables for Christmas. Then pass the cord out the zipper in the back. This works great with...

3 years ago
Forum
Reply
RE: Laser Engraver/Cutter Parts

TomL8345 wrote:Have you tried to laser cut acrylic sheet? I have engraved acrylic. Nightlight from Dollar Tree. But have not cut yet. Engraved glass...

3 years ago
Reply
RE: Laser Engraver/Cutter Parts

I have engraved acrylic. Nightlight from Dollar Tree. But have not cut yet. Engraved glass, powder coated metal, plastic, bamboo, leather. Cut w...

3 years ago
Reply
RE: Laser Engraver/Cutter Parts

This was done with an xTool D1 10w

3 years ago
Reply
Topic
Reply
RE: T-Shirts for the Christmas Community

Just added the original "ELF" t-shirt design.

3 years ago
Topic
Replies: 1
Views: 834
Page 2 / 53