Thanks. Todd how many 12v pixabulbs can I go without power injection. Do you have any anecdotal feedback. Assume a 10' direct connection to an e681 ...
Keeping in mind some programmers need the tx to go to rx and rx to go to tx. Some also require a resistor on the rst lineSent from my bat phone usin...
But I would vote for black as well if not clear Sent from my bat phone using Tapatalk
Why not clear so you can se the connections Sent from my bat phone using Tapatalk
Todd, what color/size shrink/solder sleeve would you recommend for splicing pixels and pixel wire?
Any specific kind of hot glue?Sent from my bat phone using Tapatalk
I'm looking to strips specifically for arches. Pixa-bulb on mega tree and nodes everywhere else.
So I may have to bite the bullet and go 60/20. thanks. At least I'm saving on channels. That's something..... 🙂
Right Now I have 5V 30/30. I took a 5m spool and cut them in half (75 pixels/arch). They seem to be okay visually but I'm having stability issues wit...
jchuchla wrote:I mentioned it earlier. I tested both, and couldn't tell the difference. It probably matters more in a smaller size tube. But in 2" ...
I just saw these on Amazon. Sent from my iPad using Tapatalk
How are you doing 300 pixels on a single ESPixelStick and 200 pixels on another? A universe is only 170 Pixels? Are you doubling up the pixels?
I've had similar responses from some esp chips when I was programming the espixel sticks. It was usually after I screwed up and applied the wrong volt...
I have a question on programming. I've uploaded the appropriate sketches to the RF units and the Transmitter. I can access the transmitter through the...
