If you use a design such as the Renard with PWM code installed, it should dim LEDs fine. It depends on the LED string, really. -Matt
Nice...I'm jealous... I'm planning on getting another video card soon to add a second monitor - an old 15" CRT I have lying around. My computer is o...
Would be nice (especially the backups). However, it might be a good idea to be able to turn it off. I run Vixen from my iPod and it takes a good 5 s...
There is a full list here: -Matt
Nice! I like the round design... -Matt
I just pounded a piece of thick dowel about 3' long into the lawn and slipped the end of the PVC over it. I put up some support wires (fishing line) ...
I skipped the RJ45 connectors on my control board and just soldered on the ends of the CAT5, leaving me with no way to add onto the cords when I hooke...
So this is currently hooked up to a small controller that does the flashing, and you want to hook it up to a computerized controller? Do you know wha...
Nice! And I definitely agree that cheaper is not always better...like when I tried to hook up my Renards with speaker wire or solder the SSR wires di...
I assume you mean in the preview? -Matt
I found this confusing too - maybe Vixen could set the default level of the bars to 50% or something? -Matt
Can you post a picture? Maybe you could just probe around on the controller with a multimeter and try to find which prong is the common return line. ...
The link above was mistyped: should be: -Matt
Nice Work! -Matt
I agree with all the suggestions. I had some wire-wrapped boards last year with the H11AA1 circuit on them, and I think a wiring problem may have led...
